df7993ca56
This fixes incorrect supported link modes indicated when using ethtool on the Ubiquiti UniFi AC lite / LR / Mesh. eroot@OpenWrt:~# ethtool eth0 Settings for eth0: Supported ports: [ TP MII ] Supported link modes: 100baseT/Half 100baseT/Full 1000baseT/Full 1000baseX/Full The reason for this is, that since kernel 5.4 the PHY capabilities are read dynamically from the PHY. As Ubiquiti leaves the PHY in a wrong state, the capabilities of the SGMII side of the PHY are read. As a side effect, 10 Mbit/s link modes did not work on these boards. Signed-off-by: David Bauer <mail@david-bauer.net> |
||
|---|---|---|
| .. | ||
| imagebuilder | ||
| linux | ||
| sdk | ||
| toolchain | ||
| Config.in | ||
| Makefile | ||