Pawel Dembicki d662e79468 ipq40xx: use zImage for Cell-C RTL30VW ... After switch to 5.10 kernel, kernel size was too high. This patch switches Cell-C RTL30VW from uImage to zImage build. Lzma uImage wrap is required for factory booting and it must left untouched. Signed-off-by: Pawel Dembicki <paweldembicki@gmail.com>		2022-02-08 12:38:00 +08:00
..
base-files	ipq40xx: add support for Netgear SRR60/SRS60 and RBR50/RBS50	2022-02-08 12:36:31 +08:00
files	ipq40xx: add support for Netgear SRR60/SRS60 and RBR50/RBS50	2022-02-08 12:36:31 +08:00
files-5.4/drivers/net/phy	ipq40xx: ar40xx: add switch led blink support	2022-02-07 12:33:19 +08:00
files-5.10/drivers/net/mdio	ipq40xx: 5.10: move AR40xx to MDIO drivers	2022-02-06 12:24:20 +08:00
generic	ipqx0xx: add Generic subtarget	2021-10-19 00:05:15 +08:00
image	ipq40xx: use zImage for Cell-C RTL30VW	2022-02-08 12:38:00 +08:00
mikrotik	ipq40xx: sync upstream source code	2022-02-05 12:20:39 +08:00
patches-5.4	ipq40xx: add support for Netgear SRR60/SRS60 and RBR50/RBS50	2022-02-08 12:36:31 +08:00
patches-5.10	ipq40xx: add support for Netgear SRR60/SRS60 and RBR50/RBS50	2022-02-08 12:36:31 +08:00
config-5.4	ipq40xx: enable CONFIG_CMDLINE_PARTITION and CONFIG_LEDS_TLC591XX	2022-02-08 12:27:53 +08:00
config-5.10	ipq40xx: 5.10: refresh config	2022-02-08 12:37:30 +08:00
Makefile	ipq40xx: detangle ath10k-board-qca4019 from ath10k-firmware-qca4019*	2022-02-08 12:27:10 +08:00